Reference projects
A module that reads amps is half a project; the other half is where the number goes. These walkthroughs run from the terminal block to a dashboard or a log file — wiring, the full sketch or YAML, and the mistakes that cost an evening. Start with the one closest to your setup; what differs between them is called out at the top.
13 projects
Arduino energy monitor with SCT-013 clamps: watts on an OLED, no network
Local Current-Limit with Arduino — Trip a Relay Before the Breaker, No Cloud
Raspberry Pi energy logging to CSV and SQLite in Python, no cloud
Turn a Raspberry Pi into a standalone energy logger — timestamped voltage, current, power and kilowatt-hours written to CSV (and optionally SQLite) in plain Python. No SD-card module, no RTC, no cloud; the Pi's filesystem and clock do it all.
Raspberry Pi energy monitor in Python: live watts, no cloud
Read real mains power on a Raspberry Pi in a few lines of Python — voltage, current, watts and kilowatt-hours from an rbAmp module over I²C, printed live to the terminal. No Wi-Fi service, no cloud, the on-ramp to the rbAmp Python library.
Several circuits from one Raspberry Pi: a multi-module rbAmp bus in Python
Put two or three rbAmp modules on a Raspberry Pi's I²C bus, latch them together with one broadcast, and read per-circuit power plus a coherent whole-panel total — in plain Python, no cloud, no Home Assistant.
Several SCT-013 clamps on one Arduino: metering many circuits over one bus
Trip a Relay on Over-Current from a Raspberry Pi — Local Load Control in Python
Read a circuit's current on a Raspberry Pi and switch a GPIO relay when it goes over your limit — locally, in Python, no Home Assistant, no cloud. Hysteresis and inrush debounce built in.
A PZEM-004T alternative for Home Assistant: migrate to rbAmp and keep all your history
Same entity IDs, history intact, UART freed — a one-YAML migration
Load shedding in Home Assistant: current limits, alerts and relays from your own per-circuit data
Meter branch current, cap it, shed by priority — before the breaker trips
Per-circuit energy monitoring in Home Assistant: the whole panel on one ESP32
Mains plus every branch over a two-wire I²C bus — add a circuit for the price of a module
Three-Phase Energy Monitoring in Home Assistant: 3× rbAmp UI on One ESP32
Coherent per-phase real power from three UI modules on one I²C bus — the full build
Per-circuit energy in the Home Assistant Energy Dashboard, in an afternoon — with ESPHome and rbAmp
From an unopened box to a live tile — ESP32, ESPHome, one rbAmp module
No project matches. Clear the filter.